@swordsmanluke to [email protected]English • 11 months agoDon't forget to change your z offset after swapping nozzlesmessage-square22arrow-up187arrow-down12file-text
arrow-up185arrow-down1message-squareDon't forget to change your z offset after swapping nozzles@swordsmanluke to [email protected]English • 11 months agomessage-square22file-text
minus-square@[email protected]linkfedilinkEnglish3•11 months agoDid that this morning. Except for I didn’t hit save and restart after setting new offset in klipper. But I just got a small scratch. I got lucky it wasn’t too bad. Lol
Did that this morning. Except for I didn’t hit save and restart after setting new offset in klipper. But I just got a small scratch. I got lucky it wasn’t too bad. Lol