Hello everybody,
I’m trying to read a (probably damaged) microSD card from my computer (tried with two different computers, both Arch Linux, which can read other card without any problems).
There isn’t any singal of life (no /dev/sdX, nothing with GParted, testdisk, …); the only thing that I found was in dmesg.
Here’s the output of sudo dmesg | rg "mmc0":
Any idea on how to resolve?
Sorry, this is the output:
[ 8306.605559] mmc0: cannot verify signal voltage switch [ 8306.901332] mmc0: error -110 whilst initialising SD card [ 8307.544364] mmc0: cannot verify signal voltage switch [ 8307.837385] mmc0: error -110 whilst initialising SD card [ 8308.488564] mmc0: cannot verify signal voltage switch [ 8308.789314] mmc0: error -110 whilst initialising SD card [ 8582.217859] mmc0: error -123 whilst initialising SD card [ 8584.685053] mmc0: cannot verify signal voltage switch [ 8584.982799] mmc0: error -110 whilst initialising SD card [ 8585.628028] mmc0: cannot verify signal voltage switch [ 8585.926901] mmc0: error -110 whilst initialising SD card [ 8586.573009] mmc0: cannot verify signal voltage switch [ 8586.870849] mmc0: error -110 whilst initialising SD cardThe reader can’t initalizie the SD card, so no “/dev/sdb” (nothing on lsblk also, obvioulsy).
I’ll try cleaning it better, but I already used a napkin.
mmc0: cannot verify signal voltage switchsuggests something is wrong with the hardware (either SD card or card reader).-110is a timeout error, and-123generally indicates a problem with media hardware.You’re not gonna fix this with software. Try a different card reader, or if you think it’s the SD card, put a bit of alcohol on a cotton swab and gently clean the contacts. Let the card fully dry, then try again.
Obviously this is a hail-merry shot, but your card is likely physically done for
I’ll try cleaning it with alcol. Is it a good idea to use pressurized air?
Use isopropyl alcohol
Wouldn’t hurt, yea
You can edit your post to add these details