hiya!

I got a cheap LED strip with PSU, controller, and IR remote. I didn’t look at it too much, figured it would be easy to stick it under my kitchen cabinets.

however, this thing blinks and fades and whatnot and I’m supposed to switch it over to constant light by repeatedly pressing the remote, which a) works shitty and also b) don’t wanna do that. I just want to plug it into power and it lights up and that’s the end of our interaction.

so, I opened up the PSU/controller and I’d like to locate the spots that give me +12V and GND and I can bypass the whole blinky fadey mess.

it’s a single-sided PCB. the top three wires on the right are for the IR receiver, ignore 'em. the bottom 4 are R, G, B, 12 V, respectively. I’m shorting RGB as it’s a white-only strip.

can you hazard a guess where I’m most likely to succeed?

  • CameronDev
    link
    fedilink
    English
    arrow-up
    1
    ·
    2 days ago

    When you say all the LEDs light up, do you mean they light up white?

    Those LEDs are labelled R G B, so I would have assumed they were single colour LEDs?

    • dingdongitsabear@lemmy.mlOP
      link
      fedilink
      English
      arrow-up
      2
      ·
      2 days ago

      they are white LEDs i.e. they shine white. the R G B leads are used to trigger them individually, for the running lights and whatnot. so when I bring 12 V to the V lead and GND to e.g. R, all the LEDs marked R (image) light up. when I then short R with G, then all R and G light up, etc.

      • CameronDev
        link
        fedilink
        English
        arrow-up
        1
        ·
        2 days ago

        Interesting, never heard of that arrangement before.

        • dingdongitsabear@lemmy.mlOP
          link
          fedilink
          English
          arrow-up
          4
          ·
          2 days ago

          the whole thing (5 meter strip, remote, PSU/controller) cost like $5 total so I’m guessing that’s some ingenuity at play, like reusing strips meant for RGB lights and sumsuch