Im working on a board for controlling a few linear actuators. They will at full load draw something like 10A, and will be powered by a 24V (or so) LiPo pack.
I have a few H-bridges and as expected when the power is cut off, there is an inductive kickback of about 10A. No PWM, they will be turned on and off occasionally only.
I havent been able to fibd anything on if a LiPo pack would be able to take this reverse current, or if it needs some sort of protection. It also lasts for quite a short time but I’m new to batteries so I want to be sure its not a problem.
Would apprecaite any help :)
If your lithium battery has BMS, it should be fine since a lot of BMS will have a lot of protection including over current. If your raw dog the cell, then as the other said, any voltage and current into the battery should be capped. Ideally, you should monitor each cell as well to prevent an over voltage of any of the cells in the pack. If you want to be safe without monitoring every cell, then just make sure nothing gets back into the battery. Nothing goes in = can’t get overcharged by accident from back emf.