@swordsmanluke to [email protected]English • 8 months agoDon't forget to change your z offset after swapping nozzlesmessage-square22arrow-up187arrow-down12file-text
arrow-up185arrow-down1message-squareDon't forget to change your z offset after swapping nozzles@swordsmanluke to [email protected]English • 8 months agomessage-square22file-text
minus-squareLazaroFilmlinkfedilinkEnglish3•edit-28 months agoI preheat to 170°c. That allows the filament to be soft enough to be cleaned (with tweezers or a brush, it peels off in one piece most of the time) without oozing. Then I do a 10mm retract before probing.
I preheat to 170°c. That allows the filament to be soft enough to be cleaned (with tweezers or a brush, it peels off in one piece most of the time) without oozing. Then I do a 10mm retract before probing.
That’s smart!