I have an Ender 3 S1 that I use every couple of months at this point because it’s just such a pain to use. I have to adjust the bed tramming and z offset and run auto bed leveling for every single print and often times that’s still not good enough.
It will often take 30+ minutes just to get the first layer going down successfully.
Is this a me problem or did I lose the creality lottery?
I have the S1 plus. I’ve upgraded everything from the bed to the extruder.
The biggest benefit I’ve seen is from removing the stock software and using klipper. It’s a lot to setup and calibrate, but it works well.