Context for newbies: Linux refers to network adapters (wifi cards, ethernet cards, etc.) by so called “interfaces”. For the longest time, the interface names were assigned based on the type of device and the order in which the system discovered it. So, eth0, eth1, wlan0, and wwan0 are all possible interface names. This, however, can be an issue: “the order in which the system discovered it” is not deterministic, which means hardware can switch interface names across reboots. This can be a real issue for things like servers that rely on interface names staying the same.
The solution to this issue is to assign custom names based on MAC address. The MAC address is hardcoded into the network adaptor, and will not change. (There are other ways to do this as well, such as setting udev rules).
Redhat, however, found this solution too simple and instead devised their own scheme for assigning network interface names. It fails at solving the problem it was created to solve while making it much harder to type and remember interface names.
To disable predictable interface naming and switch back to the old scheme, add net.ifnames=0 and biosdevname=0 to your boot paramets.
The template for this meme is called “stop doing math”.
It is but they change…so becarefilul with dd LOL
I mean, you should be careful with destructive changes and commands whether the interface names can change or not… And since they won’t change outside of a reboot, I’ve yet to run into a scenario where that becomes a problem as I’m looking at and making sure I’m talking to the correct device before starting anyway
Yep, i always type the line and take a break, and check the drives in another terminal first, before committing, but the web is full of people “argg I just dd the wrong drive”.