Hello all, I am considering on getting a 3D printer. I want to print some stuff for a project. I am relatively new to this. I need the slicer software to be compatible (preferably open source) with linux since that’s what I am using. I have only found the stuff from Prusa to be compatible but they are expensive. I have heard of ender 3 but it is the only os printer by creality and saw the repo is 3yo without updates.
Can I get some suggestions?
Bambu labs all the way. Unless you want your hobby to become printer maintenance.
Also unless you want to work in multiple colours and not have a giant pile of printer poop waste.
The amount of filament Bambu wastes is ridiculous.
Any multi color print is going to have waste.
It’s not as much as you might think, plus you have to purge to switch filaments with a single nozzle design. I would argue my Bambu saves filament on the balance because print failure is so low.
I think I’m wasting a lot less filament color switching with my new X1C than I ever did with all the failed prints on my old Sidewinder X2. Nothing like checking an 18 hour print at hour 17 and finding that a corner lifted or a support toppled over from all the movement.