@nieceandtows The far edge of the print shows signs of bad bed levelling, especially in comparison to the front right. The other spots where the material does not stick could be from grease/fingerprints.
Wash the print sheet with warm water and dish soap. Let it dry in a dish rack. Only touch the edges afterwards to position it again. Level the bed. Perhaps increase the overall extrusion rate.
@nieceandtows The far edge of the print shows signs of bad bed levelling, especially in comparison to the front right. The other spots where the material does not stick could be from grease/fingerprints.
Wash the print sheet with warm water and dish soap. Let it dry in a dish rack. Only touch the edges afterwards to position it again. Level the bed. Perhaps increase the overall extrusion rate.