Any ideas as to what I’m doing wrong?

This sphere has a ridge on it, and I’ve had miniatures come out with the base to be slightly offset giving a bit of a ridge.

I’m using a Halot One, lychee Slicer, and Anycubic Water Wash resin.

  • JoShmoeEnglish
    41·
    1 year ago

    That ridge looks like it’s part of the model. Can you confirm its not supposed to be there?

    • Tarnaq@lemmy.worldOPEnglish
      2·
      1 year ago

      It’s not supposed to be there, there was no ridge when I was supporting and slicing.

      • GrindingGears@lemmy.caEnglish
        2·
        1 year ago

        If it’s in the same spot every time, it’s very likely something wrong with the model. It’s inexplicable when this happens, but it does sometimes. Could try a different sd card, doubt that will make a difference, but you never know.

        To me, it looks too uniform and consistent to be something with the printer.