cm0002@lemmy.world to Hardware · 19 hours agoThese 3D-Printable Probe Clamps Make Poking at PCBs a Pleasurewww.hackster.ioexternal-linkmessage-square2fedilinkarrow-up113arrow-down10
arrow-up113arrow-down1external-linkThese 3D-Printable Probe Clamps Make Poking at PCBs a Pleasurewww.hackster.iocm0002@lemmy.world to Hardware · 19 hours agomessage-square2fedilink
minus-squarerefalolinkfedilinkarrow-up1arrow-down1·edit-217 hours agoVery cool! Really wish this had existed a couple years ago when I needed to probe some SPI signals that only had hard-to-reach bare pads on the board. Trying to solder header pins to that, especially without a third hand, was not fun.
Very cool! Really wish this had existed a couple years ago when I needed to probe some SPI signals that only had hard-to-reach bare pads on the board. Trying to solder header pins to that, especially without a third hand, was not fun.